2700 kg Capacity , 220 Volt/1 Ph , Full hydraulic.
The int-P2700 is a full hydraulic scissor parking lift.Due to the compact construction, it takes as little space and gives a perfect extra parkingplace . No post that block the way and on top of the platform complete free room.Because of the slim scissor there will remain an optimal space for simple and spacious parking. By the width of just 2,5 mtr it fits in almost any ordinary garage.and for lager buildings you can easy convert multiple lifts side by side and so make use of the maximum use of space
The low ramp ensures that very low cars can drive properly on the lift without getting stuck. It is easy to install and to move again , on almost any underground. The complete closed platform gives a maximum protection against leaking of oil and dirt.
By installing the lifts side by side it creates a floor to put cars on and under but still you can operate every single lift. The high lifting height of 2,20 mtr ( top of platform) and 2,00 mtr ( free drive trough)makes it possible for higher cars to park under.
For inside use or outside . If lack of parking spaces they are a quick and easy way to extend your parking area.Also for use as a display on a show or an attention grabber infront of your building.
Te control cabinet with the controlbuttons can be placed on anyplace near to the lift , the long hose has a range of 7 mtr.
The extra controlunit can be hang on a wall or a post for where you have the best acces .
Full hydraulic by 2 strongcilinders for a stable and strong lifting of the car.
Hydraulic synchronization byMaster and slave-cilinder ,what,in all situations, gives a goodbalanced and synchronized lifting.
Adjustable locking , so the lift can always be locked and never can sink unwilling and demagethe car underneath.
Automatic un-locking .Endswitch so the lift will always stop at the required height.
Footprotection-switch, going downthe last 20 cm, the lift will stop and a alarm signal will be heard. Pushlock and the lift will go down the for last 20 cm.